High pressure spray cleaning machine is a matching assembly line equipment that allows materials to be fully dispersed, rolled, and cleaned under the action of high-pressure water flow and bubbles after entering the water tank, and then transported to the next process through a conveyor belt. It can be widely used to clean various agricultural and sideline products such as fruits, vegetables, mushrooms, edible fungi, and seafood. It is an advanced equipment in today's vegetable processing, food, catering, and other industries, greatly improving production efficiency in industrial production.

從物料表面洗脫的污物會沉入底部隔離池，洗凈的物料出水后再經噴淋清洗，使洗凈率高且不會發生翻揚回流造成再度污染。該機自帶水循環系統，清洗槽盒低貯水箱中的水經高貯水箱過濾后，由離心泵加壓再輸入水槽，所耗水量較低，符合節水要求。

The dirt washed off from the surface of the material will sink into the bottom isolation tank, and the cleaned material will be discharged and then sprayed for cleaning, ensuring a high cleaning rate and preventing further pollution caused by overturning and backflow. This machine comes with a water circulation system. The water in the low storage tank of the cleaning tank is filtered by the high storage tank, pressurized by a centrifugal pump, and then fed into the tank. The water consumption is low, which meets the water-saving requirements.

高壓噴淋清洗機使用方法：

Usage of high-pressure spray cleaning machine:

（1）接好電源線。應根據電源的標號對應鏈接。嚴禁380V與220V錯接。

(1) Connect the power cord properly. The link should correspond to the label of the power supply. Misconnection between 380V and 220V is strictly prohibited.

注：加水前先檢查風機是否順轉然后加水，加水后再看輸送帶電機、水泵是否反轉，如倒轉，停機換線，嚴禁錯接。（未接對線前嚴禁開風機按鈕，否則水倒流，造成風機損壞）

Note: Before adding water, check whether the fan is running smoothly before adding water. After adding water, check whether the conveyor belt motor and water pump are reversed. If they are reversed, stop the machine and change the line. Misconnection is strictly prohibited. (It is strictly prohibited to turn on the fan button before connecting the wires, otherwise water will flow back and cause damage to the fan)

（2）打開總電源開關?？傠娫撮_關采用急停開關設計，以防意外?？梢詫υO(shè)備緊急停止。

(2) Turn on the main power switch. The main power switch adopts an emergency stop switch design to prevent accidents. It is possible to emergency stop the equipment.

（3）啟動風機開關。由于高壓氣流的原因，啟動此開關后，風機可能有一定的噪音，并不影響設備的使用。

(3) Activate the fan switch. Due to high-pressure airflow, after starting this switch, the fan may make some noise, which does not affect the use of the equipment.

（4）啟動網帶運轉開關。（注意：啟動網帶在啟動風機2-3分鐘后啟動）。

(4) Activate the mesh belt operation switch. (Note: Start the mesh belt 2-3 minutes after starting the fan.).

（5）蒸汽汽源連接蒸汽入口。

(5) The steam source is connected to the steam inlet.

（6）清洗機兩邊留出很大的清洗區域，方便清洗打掃。

(6) Leave a large cleaning area on both sides of the cleaning machine for easy cleaning and cleaning.

感謝您的閱讀，此文的文章來源：全自動超聲波清洗機更多的內容和問題請點擊：http://m.szoudao.com我們會繼續努力的為您提供服務，感謝您的支持！

Thank you for reading. The source of this article is: Fully automatic ultrasonic cleaning machine. For more information and questions, please click on: http://m.szoudao.com We will continue to work hard to provide you with services. Thank you for your support!